Full Spectrum CBD Oil

How to Clean The Yocan Evolve Plus XL Coils?

  • November 15 | Jeremy Lin

The Yocan Evolve Plus XL Coil is basically the whole heating unit, and the coil is literally just a coil that you put the wax on and light up. So, how to clean the Yocan Evolve Plus XL Coil is the common troubleshoot during your use it. Here are some steps for your refer to. Related post: Yocan Evolve Plus Charging Instructions

#1 Take off The Yocan Evolve Plus XL Coil from The Vaporizer

First, what you’d want to do is to remove and separate the coil from the battery, in this case, you have to twist the threaded connections to take off the coil from the vaporizer itself.

#2 Wipe the threaded and around the atomizer

Once you’ve secured the atomizer and the coil you’d want to do a bit of wiping especially around the threaded area and around the atomizer.

#3 Soak the coil into the alcohol

Once you’re done wiping this area with a clean and dry paper towel you may now take a good amount of isopropyl alcohol and fill your empty container at least to a point where the coils can be soaked and proceed to submerge the coils into the alcohol-filled container and leave it for a couple of hours.

After the coils take an isopropyl alcohol bath you may give it a little shake which helps in ousting and dislodging those hardened build ups.

#4 Using a rubber air blower remove thickened wax

After which you may take them out of the container and dry it with your paper towel, although as a tip, using a rubber air blower also helps remove thickened wax.

#5 Leave the coil out to dry

After they’ve dried up you can use a small brush to lightly graze the coils and further remove those nasty buildups. Depending on how much material your coils have accumulated, you may repeat this process until you’re satisfied. Keep soaking your coils since steeping them in alcohol will help loosen up that wax concentrates. Once they’re cleaned, dunk them on another filled with lukewarm water and leave them out to dry, I usually leave mine for half a day.

#6 Load the coil on your battery

After drying out your coils, you may replace the parts back again for one final touch. You’d want to attach the coils to a fresh set of batteries for your burn off, this is so that you’d burn some of the chemicals that could be left on the coils.

Your coils are finally good for another run. You may be wondering what those cotton swabs and paper clips are for right? Well, aside from cleaning my Yocan coils I also clean the mouthpieces around the same time. Dab the cotton swabs onto the alcohol and wipe the inside of the mouthpiece, the paper clips are for unclogging the air holes where resin and wax could have accumulated over time.

Here are some videos guide you How to Clean The Yocan vaporizer Coils.